19 November 2026 7 min read
Wood look tile sizes in Malaysia: mm, feet and square feet explained
The quotation from your contractor says 200x1200mm. The tile shop talks about boxes. Your floor plan from the developer is in square feet, because that is how the unit was sold. Three people, three units, and one question underneath: how much floor does this plank actually cover, and is it the right length for your room?
Here is every Metro plank size in millimetres, feet and square feet, what one box covers, and the size that usually fits a terrace house hall, a condo unit and a bedroom.
The four plank sizes in mm and feet
Tile sizes are stated in millimetres, width first. To get feet, divide by 304.8, because one foot is exactly 0.3048 m (the conversion factor in NIST's guide to SI units).
- 150x900mm: about 0.49 ft wide and 2.95 ft long. Roughly half a foot by just under three feet.
- 200x1000mm: about 0.66 ft by 3.28 ft.
- 200x1200mm: about 0.66 ft by 3.94 ft. In everyday terms, a plank close to 8 inches wide and just under 4 feet long.
- 200x1400mm: about 0.66 ft by 4.59 ft, the longest board we make.
So when someone asks what 200 x 1200 mm tiles are in feet, the short answer is "two thirds of a foot by almost four feet". The millimetre figure is the one printed on the box and in the catalogue.
Square feet per tile and per box
One plank covers its width times its length. Metro packs a fixed number of planks in each box, and the box coverage is what you order by.
- 150x900mm: 0.135 m² (1.45 sq ft) per plank. 8 planks a box, covering 1.08 m² (11.62 sq ft).
- 200x1000mm: 0.20 m² (2.15 sq ft) per plank. 5 planks a box, covering 1.00 m² (10.76 sq ft).
- 200x1200mm: 0.24 m² (2.58 sq ft) per plank. 5 planks a box, covering 1.20 m² (12.91 sq ft).
- 200x1400mm: 0.28 m² (3.01 sq ft) per plank. 4 planks a box, covering 1.12 m² (12.05 sq ft).
Notice that the box with the most coverage is the 200x1200mm, not the longest plank. If you are comparing quotations, compare the cost per box and per square metre (or per square foot, if that is how your plan reads), not the cost per piece, because a piece of 150x900mm and a piece of 200x1400mm are very different amounts of floor.
Boxes weigh 20 to 25 kg. In a condominium, twenty-odd boxes go up in the service lift during the hours your management allows, so plan the delivery around that.
Working out how many boxes you need
Measure the room in metres or feet, multiply length by width, add 10% for cuts and breakage, then divide by the box coverage and round up. Never round down: a floor that runs short by one box is a floor that may end up with a second batch in it.
An example. A bedroom of 3.0 m by 3.6 m is 10.8 m², or about 116 sq ft. Add 10% and you need 11.88 m² (about 128 sq ft). In 200x1200mm, at 1.20 m² a box, that is 9.9 boxes, so you order 10. Each plank page on our site has a coverage calculator that does this for you, which is the safer route for an L-shaped hall or a room with a bay.
Keep two or three spare planks from the same batch after the job, stored dry. A cracked plank in five years is then a swap, not a search for a matching shade.
Which size suits which room
The size of the room decides the plank. A plank that is long compared with the room gets cut at both walls; one that is short makes a busy floor of joints.
Terrace house hall
A terrace house ground floor is usually long and narrow, running from the main door back to the dining area and the staircase. Long planks laid along that length suit it. The 200x1400mm crosses the hall with fewer short-end joints than any other size, and the 200x1200mm does nearly the same with the widest choice of designs (61). Run the planks from the door to the back so the joints lead the eye through the house.
Condominium living and dining
Living halls in a new launch unit tend to be wider and squarer, and the floor often runs from the entrance through to the balcony door. The 200x1200mm is the size most owners settle on here. If the unit is compact, the 200x1000mm is easier to handle around a kitchen island or a short corridor. For colour and surface choices in these rooms, read wood look tiles for the living hall and bedroom.
Bedrooms and study
In a bedroom of about 3 m across, a 1200 mm plank gives two and a half planks a row. That works well with Metro's quarter offset (300 mm on 200x1200mm), because the offcut from one row usually starts the next. In a smaller room, or a study with built-in cabinets, the 150x900mm is the easier plank: narrower, closest to a sawn timber board, and the size with the most designs (70).
Wet kitchen, bathroom and stairs
Small, cut-heavy areas favour the 150x900mm. It is also the size that spans a 900 mm stair tread in one piece. Our guide to bathrooms and wet kitchens covers surface choice for the wet areas.
What the size on the box does not tell you
The joint adds to the module. Metro planks have a curve edge formed in the mould, so they are laid with a 3 to 5 mm joint, using spacers of at least 3 mm. A row of planks is therefore slightly longer than the sum of the tiles. It is one reason for the 10% allowance.
The calibre code. Each box carries a calibre code, a band of actual length. Lay one room from one calibre and one batch, and order the whole floor at once.
Thickness. Planks are 9 to 9.5 mm thick. If you tile over an existing floor, add that to the adhesive bed and check the clearance under the main door and any sliding balcony door.
The material. Metro tiles are glazed ceramic, with a body that absorbs 6 to 8% of its weight in water, which is group BIIb under EN 14411, the European ceramic tile standard. The size does not change that; every size has the same glaze on top.
Picking the size first, then the design
Choose the size for the length of the room, then pick from the designs made in it. Of the wood look and timber look tiles we make, the 200x1200mm has the most Matt Texture designs (41), which matters if the floor runs into a wet kitchen or out to a balcony. The Oaklore family is made in all four plank sizes, so a design such as Oaklore Beige in 200x1200mm can follow you into a bedroom in a shorter plank.
Every size and design is in the downloadable catalogue. If you send us the room sizes, we can suggest a plank and a box count before you visit a shop.
Planning wooden tiles for your home?
Tell us the room and the size you have in mind. Our team replies within 24 to 48 hours, and we can post you a sample first so you can see the surface in your own light.
Frequently asked questions
What is 200 x 1200 mm in feet?
About 0.66 ft by 3.94 ft, which is close to 8 inches wide and just under 4 feet long. One plank covers 0.24 m², or about 2.58 sq ft.
How many square feet does a box of 200x1200mm tiles cover?
12.91 sq ft, which is 1.20 m². Each box holds 5 planks and weighs about 25 kg.
Which tile size is best for a terrace house?
200x1400mm or 200x1200mm, laid along the length of the hall from the main door. Long planks give fewer joints in a long, narrow room.
What size should I use in a condominium bedroom?
200x1000mm or 200x1200mm in most bedrooms of around 3 m across. In a small room or a study with fitted cabinets, 150x900mm gives fewer awkward cuts.
How much extra should I order?
Add 10% to the measured area for cuts and breakage, then round up to whole boxes. Keep a few spare planks from the same batch after the job.
Do longer planks need a flatter floor?
Yes. A 1200 mm or 1400 mm plank shows every dip in the screed more than a short one does. Ask your contractor to check the base is flat before you choose the longest size.