16 November 2026 7 min read
How to clean wooden tiles: daily care, grout, stains and what to avoid
A wooden tile floor in an Indian home gets swept and mopped more often than almost any floor in the world. Dust blows in through open windows, footwear brings in grit from the road, and the house help mops the whole house every morning.
Wooden tiles handle that routine well, because the wood grain sits under a fired glaze. What wears out is usually not the tile. It is the grout, and it is damaged most often by the cleaner meant to clean it. This guide covers the daily routine, the grout, common stains and what never to use.
The daily routine
Sweep or dry mop first, every day. Fine sand and road grit are the only things in a normal home that can dull a glaze over time, and they do it by being ground in under footwear and chair legs.
Then mop with clean water and a small amount of mild, pH-neutral floor cleaner. Two buckets help: one for the cleaning water, one for rinsing the mop. Change the rinse water when it turns grey, because a dirty mop only spreads the dirt across the whole floor. A grout cleaning bulletin from TEC, an installation products maker, gives the same advice for routine care: a pH-neutral cleaner.
Wring the mop well. A wet floor is not a problem for the tile, but water left standing in the joints carries dirt into the grout.
Why matt and satin floors clean differently
Metro makes three surfaces, and they behave differently under a mop.
Satin Plain is smooth with no relief. A damp mop clears it in one pass.
Satin Texture has a light grain relief. A microfibre mop reaches into it without effort.
Matt Texture has the deepest grain relief, which is why it is the surface for bathrooms, kitchens, balconies and stairs: the relief gives grip. The same relief holds a little more dirt. Once a week or so, go over it with a soft nylon brush or a scrubbing pad meant for tiles, and rinse. Never a wire brush or steel wool.
Grout: the part that actually needs care
The glaze on a wooden tile does not absorb a stain. The grout is cement-based and porous, so it does.
- Keep it from darkening: the dark line that appears in walkways is dirt carried into the joints by dirty mop water. Clean water and a wrung-out mop prevent most of it.
- Seal it, if you want an easier life: LATICRETE's tile and grout care page notes that grout joints typically need sealing and proper maintenance to prevent stains and discolouration. A sealed joint gives you time to wipe up a spill before it soaks in.
- Deep clean a few times a year: a grout cleaner sold for tile joints and a stiff nylon brush, then a rinse with clean water.
- Choose the colour with this in mind: a mid or dark grout close to the plank tone hides daily wear far better than a pale grout. The curve edge on Metro tiles already gives each plank a shadow line, so a matched grout keeps the board effect.
Stains you will meet in an Indian home
Turmeric and haldi: wipe it off the tile at once; it will not stain the glaze. On grout, a paste of baking soda and water left for a few minutes, then a nylon brush, lifts most of it.
Cooking oil: warm water with a little dishwashing liquid, then a clean water rinse. An oil film left on the floor makes it slippery.
Rangoli colour and gulal: sweep or vacuum the dry powder before it gets wet. Mopping first turns it into a dye that runs into the grout.
Candle wax and diya oil: let wax harden, lift it with a plastic scraper, then wipe the oil mark with warm soapy water.
Hard water marks on a balcony or near a tap: warm water with a little dishwashing liquid and a microfibre cloth. For heavy build-up, use a limescale remover labelled safe for glazed tile and cement grout, and try it on a spare tile first.
Paint, cement or tile adhesive splashes after renovation: lift fresh splashes with a plastic scraper. Grout haze left by the tiler should be cleaned off on the day of grouting; old haze needs a cleaner made for it.
What not to use on wooden tiles
- Acid (tejab) and acid "tile cleaners": often used in Indian homes to brighten a floor. Acid eats cement grout and leaves the joints hollow and rough, and it is not meant for a glazed surface. LATICRETE lists acidic and alkaline cleaners, bleach, abrasives and ammoniated cleaners among the products it does not recommend for tile and grout.
- Bleach and strong chlorine cleaners: fade and weaken coloured grout with repeated use.
- Scouring powder and steel wool: scratch the glaze, and the scratches then hold dirt.
- Wax, polish and oil-based "floor shine": a glazed tile does not need them. They leave a film that becomes slippery and attracts dust.
- Floor cleaners that leave a film: if a cleaner says "no rinse", rinse anyway on a textured floor.
What wooden tiles do not need
They do not need the annual polishing, sanding or termite treatment that real wood asks for. They do not need sealing on the tile face, because the glaze already does that job.
They do need a few spare tiles. Any glazed tile can chip if a heavy steel vessel lands on its corner. A chipped plank is lifted and replaced, and a tile from the same batch matches. Keep a box back when the floor is laid.
Put felt pads under chair and sofa legs, and a doormat at each outside door. Most wear on a tile floor starts at the entrance.
A short care plan
Daily: sweep, then a damp mop with clean water and a neutral cleaner. Weekly: a nylon brush over Matt Texture areas. Every few months: deep clean the grout and reseal if it was sealed. Never: acid, bleach, wire brushes or wax.
Room-specific advice is in the guides for kitchens and bathrooms. If you are still choosing a floor, the 200x1200mm range has the widest choice of Matt Texture designs, and our team can send samples for you to test with your own mop and cleaner.
Planning wooden tiles for your home?
Tell us the room and the size you have in mind. Our team replies within 24 to 48 hours, and we can post you a sample first so you can see the surface in your own light.
Frequently asked questions
How do you clean wooden tiles every day?
Sweep or dry mop first, then mop with clean water and a little pH-neutral cleaner. Wring the mop well and change the water when it turns grey.
How often should wooden tiles be deep cleaned?
The tile face needs only the daily mop. Brush Matt Texture areas about once a week, and deep clean the grout a few times a year, more often in a kitchen or at the entrance.
Can I use acid to clean wooden tiles?
No. Acid attacks the cement grout between the tiles and leaves the joints rough and hollow, and it is not meant for a glazed surface. Use a cleaner made for tile and grout instead.
How do I clean black grout lines on a wooden tile floor?
Scrub the joints with a grout cleaner and a stiff nylon brush, then rinse with clean water. Sealing the grout afterwards helps it stay clean longer.
Do wooden tiles need polishing?
No. The surface is a fired glaze, so it needs no polish, wax or sanding. Wax and polish leave a slippery film on tile.
Will turmeric stain wooden tiles?
Not the tile. The glaze wipes clean. Turmeric can stain pale grout, which is why a mid or dark grout is the better choice in a kitchen.